Quote Originally Posted by tom4bren View Post
Vette,

Correct, IIRC the Mechatech install instructions do not describe removing the splined shaft from the hub assembly. For those instructions, go to the How2 section and get Kenny's bearing repack write-up.

http://www.vehicross.info/modules.ph...warticle&id=59

Also consider that all of the vendors that we've talked to seem to only supply the tripod version (3 ball bearing). Rumor has it that it'll fit into our 6 ball bearing cup. My concern for this swap would be strength and binding at full articulation ... but members say that they work just fine.

Tom
The NAPA unit pictured by SilverBullit shows at least 3 ball bearings in view. I'd assume the other 3 are present on the backside of the pic. Am I misunderstanding your point?

OK. I looked at the bearing repack procedure. Once the hub is pulled, I assume you're telling me the CV "halfshaft" free to come out?