Thanks for all the tips and help.
It's been a challenge, but I'm almost done and will post a pic of the finished product later in the week.
A few issues that came up:
I broke all but one of the Christmas tree holders. In addition, where these mount to the inside of the cladding one of the holder housings broke off. Anyone know what type of adhesive works on our plastic cladding so I can reattach this?
The holes on the hitch did not line up with the holes in the frame so I had to drill all of the holes. In additon, the holes in the backplate were too high for the holes that I drilled in the front so I had to redrill those as well. I mounted the hitch as high up as it would go and still the backplate just didn't line up...
Cutting the cladding was a breeze and it mounts right up with a good clean finish.
Thanks again for the help.
Reply With Quote