Window Gremlins have visited

[Mile High VX]

Did my drivers side yesterday with the SBC bracket. No matter ( spacers, washers, bungee ) what I do the smaller front wants to shift down on me. Tracks and rubber channel looks fine.

Same issue with my passenger side as well, but now at least it stays on the regulator instead of falling into the door.

From what I see, in my case, is that the plastic guide on the regulator is broken on the forward side. This allows the front to tip in instead of staying level.

Works great going down, but going up is another story...

[waaaaht]

Same issue with my passenger side as well, but now at least it stays on the regulator instead of falling into the door.

From what I see, in my case, is that the plastic guide on the regulator is broken on the forward side. This allows the front to tip in instead of staying level.

Works great going down, but going up is another story...

yup yup same here

[Mile High VX]

New window regulator showed up today so I had no choice but to get the VX back into top shape (couldn't have it just falling apart)...

Pretty easy exchange. Had to be careful with the three phillips heads that held the motor to the regulator. They're soft metal and mine were extremely tight and hard to break loose. Without the right bit it would have been easy to strip the heads.

Interesting to find that the bottom bolts for the center rail had spacers between the door frame and the rail...who knew????

Pretty easy to get the window adjusted with the SBC bracket AFTER I got it into both the front and rear tracks correctly.

Works great now and this was the second step to the fix that my window required.