How do I replace my Oil Cooler Hoses?

[JAMAS]

Perfect!

Thank you.

Now I will need to do a little forum searching for how to top off my tranny fluid.

[evillecutter]

Perfect!

Thank you.

Now I will need to do a little forum searching for how to top off my tranny fluid.

warm it up, park on a level surface - go up and down slowly through all the gears - leave it running - get underneath and unscrew the top bolt - if it leaks out its full, if it doesnt get a pump and pump fluid into the top hole until some pours out - screw bolt back in

[JAMAS]

warm it up, park on a level surface - go up and down slowly through all the gears - leave it running - get underneath and unscrew the top bolt - if it leaks out its full, if it doesnt get a pump and pump fluid into the top hole until some pours out - screw bolt back in

Two questions...

1. How would I go through all the gears while parked?

2. Can I do it without leaving it running? that feels not so safe.

Thanks

[JAMAS]

Two questions...

1. How would I go through all the gears while parked?

2. Can I do it without leaving it running? that feels not so safe.

Thanks

Nevermind, I found the page in the tech manual. (7A–10)

you were right on the money with how to do it.

1. Park the vehicle on level ground and apply the parking brake firmly.

2. Check fluid level with engine running at idle.
NOTE: Be sure that transmission fluid temperature is below 30C (86F).

3. Move the selector lever through all gear ranges.

4. Move the selector lever to “Park”.

5. Let engine idle for 3 minutes and open the overfill screw (1).

6. Add released transmission fluid until it flows out over the overfill screw opening.

7. Let engine idle until a fluid temperature between 32C (90F) and 57C (135F) is reached, then close the overfill screw (1).
Torque: 38 N•m (28 lb ft)

NOTE: To prevent fluid leaks, the overfill screw and oil drain screws gasket must be replaced each time these screws are removed.