Sounds like you are having fun!
Did the gears and lockers get installed?
Hope all goes smooth!
Super VXer
Sounds like you are having fun!
Did the gears and lockers get installed?
Hope all goes smooth!
Billy Oliver
15xIronman
My Sponsors:
Accelerate3Coaching
TriSports.com (PM me for 1 time use 20% off code)
Super VXer
We are getting there...
...Originally Posted by Triathlete
Front pumpkin and locker/diff drop and selectable hubs are done.
Rear pumpkin and Transmission fluid change tomorrow.
A few bits of grinding for trooper skid plate clearance on drive shaft...
.....figure out the cross member ( just had a good chat with dub)
...and she'll be ready for Moab abuse
jo
VX.info...PLEASE SUPPORT THIS SITE WITH YOUR VOLUNTARY $20 DONATION...
Absolutely the best $20 you'll spend per year on your VX.
~ ~ > OFF ROAD WHORE <~ ~
[SIGPIC][/SIGPIC]
Super VXer
Just FYI...
Having chatted with Dub and looked at the cross member again...
....I do believe I am going to cut Toms "H" brackets down leaving
a 1/2 - 3/4 inch "stub" where he had the bolt holes for the c/member
on the lower legs of the "H"
It will essentially leave a saddle bracket with stubs.
I will weld the Calmini c/member to these stubs ( extra surface area)..
...and that will secure it solidly, AND tuck it up a bit higher for clearance.
It will still be removable with 4 bolts as before.
Any comments and / or derision () glady accepted!
jo
Super VXer
I've got a set of CM drop brackets that were designed for the Calmini CM. If you like, I can get them in the mail today.
[SIGPIC][/SIGPIC]
Put a smiley after you say that Bub.
Posting Permissions
Reply With Quote
