Powered sub's

[etlsport]

How'd you get the RCAs through the door loom?

it sucked a whole lot! I pulled the two strands apart as far as possible so the connectors could be fed through one at a time. then i just inched them through. it makes it easier to remove both sides of the loom so you can pull it out a bit.

what i have done since then for additional speaker wire and such is get a 5-6" piece of thin wall pipe barely large enough for my wires to pass through and push that through the loom, feed the wires through the pipe then remove the pipe in the direction you fed the wires. this method is super easy, should work for an rca cable too

[eternal21]

it sucked a whole lot! I pulled the two strands apart as far as possible so the connectors could be fed through one at a time. then i just inched them through. it makes it easier to remove both sides of the loom so you can pull it out a bit.

what i have done since then for additional speaker wire and such is get a 5-6" piece of thin wall pipe barely large enough for my wires to pass through and push that through the loom, feed the wires through the pipe then remove the pipe in the direction you fed the wires. this method is super easy, should work for an rca cable too

Thank you. I'd like to see if I can get 1 set of RCAs, 1 4G, and 4 pairs of 12g speaker wire through there....