the corner of the hood cladding by the passenger window is raised off of the hood... what tape do i use to stick it back to the hood?
Thank you
Printable View
the corner of the hood cladding by the passenger window is raised off of the hood... what tape do i use to stick it back to the hood?
Thank you
Hummm??? The stock Hood insert is held in there with bolts, if that's what we are talking about. Other than that, there isn't any cladding on the hood?:confused:
well the corner of the hood insert is poping up, just the very corner, it looks like it had a 3m tape or something under... i guess its warpped? but it easily can be pushed down to the hood again so woulda 3m tape work or what would you all suggest using?Quote:
Originally Posted by Techy-D
What i'll suggest you to do is to remove the under hood isolating cover,is the black sheet & see if there's any missing nuts :)Quote:
Originally Posted by killinformula
Note that the washer nozzles are also responsible for holding down the hood insert.Quote:
Originally Posted by Gussie2000
Also, is it possible that the previous owner did tape over the hood? It should be a flat black, and might have a couple cracks in it... but I don't think it peels...
Chances are, the adhesive holding the stud to the bottom of the insert has let loose, removal of the insert & a bit of JB Weld should fix you right up, just don't over tighten during re-assembly.Quote:
Originally Posted by killinformula
Or, as stated earlier, you could be one nut short of complete insert restraint...:smilewink
Check my gallery for a solution most wouldn't touch with a ten foot whatchamacallit...:_wrench:
BFS!:bwgy::smilewink:grino::bwgr:
**Big F'in Staplegun!**
looks like i will be taking it off this weekend.... its just those bolts and it comes off nice and easy right?Quote:
Originally Posted by Ldub
check the downloads section for the full shop manual. I can only assume it has complete instructions on how to pop that sucker off.
Yep, though some of those bolts are hard to see. And, as mentioned earlier, the washer squirters have to be removed too.Quote:
Originally Posted by killinformula
While you have the insert off, take apart the drain tubes under the insert & clean them out too, they're under the leading edge of the insert...:_wrench:
Just pull the hose off of the drain cup & clean it out with some warm water & a pipe cleaner or piece of wire.
They will get clogged up again in about two weeks, but it's easy to do after you see how they go together.
Also, give the hood under the insert a couple coats of wax.