Transmission DIED!!

[LittleBeast]

The only think I wish I would have done was have all the O2 sensors removed and replaced; I'm looking at taking my exhaust down again to do that this winter but it will all come down easier cause I used stainless steel hardware and it's new so it won't seize and breakup off on me again.

I replaced all 4 O2 sensors in a matter of 1 to 2 hours with no removal of any exhaust components just a few months ago. Why would you drop the exhaust to do this?

[CowboyErik]

I replaced all 4 O2 sensors in a matter of 1 to 2 hours with no removal of any exhaust components just a few months ago. Why would you drop the exhaust to do this?

My 2 rear's are fused in place; used acetalene torch, had them glowing and still could not get them to turn; gonna have to cut out the mounts and weld in new ones, then install new sensors; likely got the same problem with the fronts; carbon filth the engine builds up bit time on sensors; codes went away for a while after heating them up I guess because I burned off all build-up. they just get fouled badly