Help from a Denver VXer?

[jasonm621]

I have the pre drilled bar "tool" to get that crankshaft pulley nut off and back on torqued to spec. Youre more than welcome to using it! I probably couldnt help much with the mystery clunk but i think if i had to do a timing belt again i could do it in about half the time! I just bought the all in one dayco kit from autozone. It comes with the belt, tentioner, tentioner pulley, Idle pulley, and the water pump. Pretty nice kit although there is no marks on the timing belt. Its not a problem as long as you pay very close attention to the marks on the cams and project those marks over to the new belt with a silver sharpie... Let me know when you wanna take the plunge and we can have that beer we were talking about!

[Mile High VX]

I'm planning on being there for awhile...

VxSport if you're coming through Castle Rock let me know and we can convoy over to Starbucks!

[VxSport]

Sounds good to me..... meet at your church? 9:45?

I'm planning on being there for awhile...

VxSport if you're coming through Castle Rock let me know and we can convoy over to Starbucks!

[Mile High VX]

Sounds good to me..... meet at your church? 9:45?

Works for me...see you Sunday.

[twalker920]

I have the pre drilled bar "tool" to get that crankshaft pulley nut off and back on torqued to spec. Youre more than welcome to using it! I probably couldnt help much with the mystery clunk but i think if i had to do a timing belt again i could do it in about half the time! I just bought the all in one dayco kit from autozone. It comes with the belt, tentioner, tentioner pulley, Idle pulley, and the water pump. Pretty nice kit although there is no marks on the timing belt. Its not a problem as long as you pay very close attention to the marks on the cams and project those marks over to the new belt with a silver sharpie... Let me know when you wanna take the plunge and we can have that beer we were talking about!

Definitely! Can I ask how much the Autozone kit cost?