Justin, I totally see where you are coming from with the "get it done, then mess with it" line of thought, but remember, I like to pre plan out way ahead, so all my research is pretty much done and I just go do it when the time comes. I remember reading about the neck down shafts before too. Are you going to just try and find some from another D60 or wait until you actually need them? As for your meeting up idea, I'm all for it. What kind of bender are you looking at getting? The one I was building uses pro tools 105 dies. I haven't had the opportunity to use my tube notcher yet I think it's made by protools too, but if you need one in the meantime, I can mail it over to you. Also, do you remember what that site was that you told me about with the LS motor mounts that were adjustable?
Reply With Quote