Quote Originally Posted by Marlin View Post
Also went ahead and did the drivers window bracket with the SBC brackets. DIdn't help the drivers window go up any better Actually I think its worse now I tried sliding the glass around, might have to try and push it forward in the slots some more.
Quote Originally Posted by vt_maverick View Post
I had the same experience, the SBC brackets made a huge difference in the passenger side but didn't make as much difference on the driver's side (still have to "help" the window up). It goes up just fine after it gets about 2 inches out of the door, but IMHO that's still not good enough.
Well, this sounds familiar.

The previous owner had installed the SBC brackets before I bought the VX. The passenger side works perfectly but the driver's side would still twist forward while being raised. Silicone spray made it work great for about a month, and a second application helped when it needed again later, but was the result was not nearly as good. A few weeks ago I took the window out while replacing the lock assembly.

When I reinstalled the window, the twisting was the worst ever until I slid the SBC bracket as far toward the door hinges as possible. No more twisting, but now I get a little wind noise on the highway. There is also a worrying "thunk" as the window completely closes that makes me think the top of the window is not aligned properly with the upper channel. Seems to be a fine balancing act.

I would have kept trying to find the sweet spot, but there is so much slop throughout the entire regulator assembly that I was left with the impression that it is just plain ol' worn out. (Lots of speculation on my part since this is the first time I ever played with "door guts.") Once I have time to mess around with it again, I intend on comparing it to the passenger side regulator before I actually start shopping for a replacement.