So,,,,,,, went to replace the outer driver side boot...... Ran into a few snags. Two of the bolts in the lower a arm (the rear two) were to sunken in to get a wrench onto and were spinning making it impossible to take off lower ball joint and slip everything out. This led to hours of frustration and to taking apart upper ball and a few other pieces and yeah hate the damn abs line feed bye the way. Finally removed entire shaft and stripped everything apart. CV's both still looked good reassembled with one small problem the band clamps for the boots were crap and two of the four broke while tightening. Have industrial zip ties on there for now anyone know of a good clamp that you can slip on after the fact that will work. Can I use a worm drive clamp without any issues?