Identify which roof rail position this is?

[Ldub]

Can anybody identify it's position?

It would appear to be laying down.......

[rowhard]

Morning Sue. Look on page 14 of the VX Parts Manual available here under downloads, you will find the part numbers for those. Hopefully they are also molded on the under side of the parts.

[VX KAT]

If you have a full set to compare it to, I think you could figure it out pretty easily...

Otherwise, test fit it on all four corners of the thing that holds up your roof basket to see which position works best...

I would check it without fully clipping it on, since it appears that one of the tabs is already broken.

Morning Sue. Look on page 14 of the VX Parts Manual available here under downloads, you will find the part numbers for those. Hopefully they are also molded on the under side of the parts.

Thanks John. It appears the modding cut off the part that would have the part #. I'll play with it by just positioning it on mine. I'll see if Bart or Kenny want a spare.

It would appear to be laying down.......

There you go again, Mr. funny! I think that night job makes you funnier....or
maybe it's the lack of sleep!

[rowhard]

well, that sucks

[Ldub]

IIRC, the position of the caps is molded into the bottom side too. (L/F - L/R -etc)

I know that doesn't help if it's already been cut...I was just showin' off......

[nfpgasmask]

It's hard to say from the photo. The front ones are slightly smaller than the rears.

Bart

[nfpgasmask]

Looking closer at it, I would guess its from the rear.

Bart

[tomdietrying]

Kat,
I'll take it if they're still available? I'd like to do that mod to mine, so this would be a great template.
Peace.
Tom