bad fuel pressure regluator symptoms

[rowhard]

Nice close up. Any chance you could take another shot, but this time pull back so we can see where you are in the engine compartment?

[VCrossfan]

I used this very nice process written up by Dino..

http://www.vehicross.info/forums/showthread.php?t=12021

[rowhard]

I used this very nice process written up by Dino..

http://www.vehicross.info/forums/showthread.php?t=12021

Oh yea, remember that. Sure wish Dino, aka bandit was still had his VX

[Vehi-Cross-Az]

Nice close up. Any chance you could take another shot, but this time pull back so we can see where you are in the engine compartment?

sure, here you go

[rowhard]

thank you much

[Triathlete]

Hey Az, saw you today! You were in the turn lane on Mission (turning east on Ajo). I was going the opposite way and waved but I don't think you saw me.

[WormGod]

Just out of curiosity, did you have any issues with the new snap ring that came with your FPR? I just replaced my FPR for the second time and found that I had to keep using the "original" snap ring, both times. The one that came with the new ones was not only too small and wouldn't snap tight into place (with the S/C FPR block as well as the OEM FPR seat) but it was actually a different design altogether.

Anyways, just curious. Maybe I got the 2 flunkies that existed, heh.

[Ldub]

Just out of curiosity, did you have any issues with the new snap ring that came with your FPR? I just replaced my FPR for the second time and found that I had to keep using the "original" snap ring, both times. The one that came with the new ones was not only too small and wouldn't snap tight into place (with the S/C FPR block as well as the OEM FPR seat) but it was actually a different design altogether.

Anyways, just curious. Maybe I got the 2 flunkies that existed, heh.

Had the same experience when I changed mine last summer.

[VCrossfan]

Just out of curiosity, did you have any issues with the new snap ring that came with your FPR? I just replaced my FPR for the second time and found that I had to keep using the "original" snap ring, both times. The one that came with the new ones was not only too small and wouldn't snap tight into place (with the S/C FPR block as well as the OEM FPR seat) but it was actually a different design altogether.

Anyways, just curious. Maybe I got the 2 flunkies that existed, heh.

Same (at least a snap-ring prob) but the one in the kit was to thick.

[Vehi-Cross-Az]

Hey Az, saw you today! You were in the turn lane on Mission (turning east on Ajo). I was going the opposite way and waved but I don't think you saw me.

that was me !! lol nuts, didnt see you
I tend to zone out sometimes when Im driving, sorry
next time just lay on the horn a few times haha jk