Well, I un-packed the molds today since I now have my workshop in working order, can't say the same about me. For sure, they are going to need some work and TLC, they are rough. But that's okay since I still have some time off thanks to fine management where I work. Getting them perfect will be the easy, but time consuming part. Just a case of fill and sand, once they are right will lay a tooling gelcoat on them so I can produce a master set of plugs, then a master set of molds from the new master plugs. As far as the hood insert, still haven't been able to source the mounting hardware. Have a local hardware provider working on that, but no news in 2 weeks. If anyone out there can help me with this, it would be greatly appricated.