Skid Plates and Hood Inserts

[pbkid]

sounds good....any hope on doing something like a 4runner hood scoop on the insert??

[TheGanzman]

sounds good....any hope on doing something like a 4runner hood scoop on the insert??

Count ME in!

[Baldwin]

Skid plates look great! I'm down for front and sides.

[rowhard]

Well, I un-packed the molds today since I now have my workshop in working order, can't say the same about me. For sure, they are going to need some work and TLC, they are rough. But that's okay since I still have some time off thanks to fine management where I work. Getting them perfect will be the easy, but time consuming part. Just a case of fill and sand, once they are right will lay a tooling gelcoat on them so I can produce a master set of plugs, then a master set of molds from the new master plugs. As far as the hood insert, still haven't been able to source the mounting hardware. Have a local hardware provider working on that, but no news in 2 weeks. If anyone out there can help me with this, it would be greatly appricated.

[pbkid]

well would it just be a matter of ordering a fiberglass or plastic insert and then create a mold of it as part of the cladding??

Quan. Part # Description Price
(1) 76181-35901 (Hood Scoop Insert) $82.09
(1) 76182-35020 (Guide) $ 9.77
(1) 76192-35010 (Plate) $ 9.49
(2) 90269-04054 (Rivet) $ .43 (x2 = $ .86)
(4) 75567-21030 (Protector) $ .77 (x4 = $3.08)
(1) 90167-45005 (Screw) $ .52
(1) 76187-35010 (Retainer) $ .64
(4) 76183-12030 (Protector) $ .52 (x4 = $2.08)
(2) 76184-12020 (Protector) $ .52 (x2 = $1.04)
(1) 76185-35010 (Protector) $ 5.04

is something like that helpful?? these are part numbers from toyota
got it from here-
http://www.yotatech.com/f12/wtb-4run...-insert-96001/

let me know if that helps at all...

[Ldub]

As far as the hood insert, still haven't been able to source the mounting hardware. Have a local hardware provider working on that, but no news in 2 weeks. If anyone out there can help me with this, it would be greatly appricated.

Hey John...look what I found...

Don't know if they come in different lengths or sizes, but it might be a starting point.

Maybe could be used in conjunction with a coupler nut & threaded rod?

http://dragonplate.com/ecart/categories.asp?cID=21

[Ldub]

Finally was able to find just what you were looking for John...

Adhesives & everything...

http://www.weldmountsystem.com/parts.htm

Scroll down...enjoy!

[don moore]

good find .