Progress!
I went out yesterday and rented a stall in a DIY garage here in Denver. Not a bad deal, I payed $35 for an hour in a stall that includes a lift and all the tools including air tools you need. Well worth it especially considering it was snowing and my garage is not heated. HD lower links installed in about an hour. The only issue I have is the location of the grease fittings. If I put them on top then they looked like they would break off when suspension is fully compressed so I have them on the bottom. I will definitely break these off the first time they see a rock so I'm going to replace the zerks with flush mount fittings. Question for those that have done this upgrade: Did the width of the bolt sleeve, for lack of a better term, cause the brackets to pinch in slightly?