VT_Maverick's 5 Speed Swap

[vt_maverick]

Greg - Couple questions for you:

First, is that the catalytic converter in the upper left of this pic? If so man that's a lot of rust!


Second, I assume you have the wires zip-tied to the cross-member. Do you think there will be a problem when I reinstall my Kilby skid plates? And do you think I could just "lay" it in the bottom of the skid plate?


Last, do you still need the connector you mentioned in the earlier post? Or did you work something out?

Lookin' awesome Greg!!!

[Buffy]

Greg - Couple questions for you:

First, is that the catalytic converter in the upper left of this pic? If so man that's a lot of rust!


Second, I assume you have the wires zip-tied to the cross-member. Do you think there will be a problem when I reinstall my Kilby skid plates? And do you think I could just "lay" it in the bottom of the skid plate?


Last, do you still need the connector you mentioned in the earlier post? Or did you work something out?

Lookin' awesome Greg!!!

Yes that is the cat in the first picture, there really isn't as much rust on the pipe as it looks in the picture. It just looks dirty in the pictures. If there were tons of rust that I was not comfortable with I would have let you know about it.

The wire is held to the cross member with factor ties and is in its original location. It should work fine with your Kilby skid plate if you previously did not move these wires.

Jerry is sending me the connector I was wanting. He even went as far as to mark which wires should tie into clutch switch, etc. I hope to get that in the next day or so and get this puppy back on the ground and back in your anxious hands!