Brotha Dub,
I'm usually not into the spike thang but they look real nice.
Are they pressed in or threaded? It looks like they went into existing holes on the rim so what did you have to drill?
Super VXer
Brotha Dub,
I'm usually not into the spike thang but they look real nice.
Are they pressed in or threaded? It looks like they went into existing holes on the rim so what did you have to drill?
[SIGPIC][/SIGPIC]
Put a smiley after you say that Bub.
Super VXer
Originally Posted by tom4bren
Thanx T man...
What look like existing holes are just decorative indents, made centering the drill bit E-Z...
The studs are threaded on the inside, & held on from the back side of the rim by...what else?...stainless cap screws...
Oh, & let's not forget...a little loc-tite.
Last edited by Ldub : 04/24/2010 at 03:42 AM
Super VXer
You drilled all the way through the rim??? Not sure I'da had the nerve for that!!!
Super VXer
It's only the webbing between the spokes, didn't drill through anything that's crucial to keeping compressed air on the inside...
Each hole is only large enough to accept a stainless 8-32 cap screw.
Super VXer
Looks awesome Dub..
But remind me to drive in front of you which every year I think I have.. Just in case one breaks off.. Dont plan on changing a flat on a trail this year lol.
Seriously tho looks like rim came that way very nice touch..
I never understood why people keep things the same and never personalize.
"It's not sexual harassment, I am just building up your tolerence"-Dumke
Super VXer
Because most people have no personality to begin with. And then there are people like Ldub, who have an abundance!!
Bart
Posting Permissions
Reply With Quote
