Quote Originally Posted by Cobrajet View Post
If the bottom notch was beveled like all of the other notches, I would think the headrest would then be removable. A bench grinder should be able to take care of that.

Is the pin be too deep/long to allow reinserting the headrest?

Can the sping/pin be removed without removing the plastic sleeve? It looks accessible.

Here's what I'm thinking...

1) remove the seat back
2) pop off the spring/pin assy
3) remove the headrest
4) bevel the last notch
5) reinstall the headrest
6) reinstall the pin assy
7) reinstall the seat back
I tend to take the path of least resistance...AKA, the easy way out...

I'm thinking bevel the last notch in place with a dremel...