CVs from Autopartswarehouse

[tom4bren]

"I think I will take mine out and go do some comparisons."

My spare set (unassembled) is in my garage so you may not have to remove yours (I heard it's a major pain). I'll try to take some pix so you can let me know what measurements you need me to take.

[CrnCnn]

Somewhere in the archives should be a post from grandpa bob or green dragon, where he mentioned that only one side of a troopers front cv's are a direct interchange with the vx. He actually had a spare and used them.

See this is great. Tips start rolling in for some solutions/places to look closer.

"I think I will take mine out and go do some comparisons."

My spare set (unassembled) is in my garage so you may not have to remove yours (I heard it's a major pain). I'll try to take some pix so you can let me know what measurements you need me to take.

Well, I have to take apart my drivers side to see if thats where my noise is anyhow but I may not leave it out so you might be getting a PM from me. Thank you

[tom4bren]

"Well, I have to take apart my drivers side to see if thats where my noise is anyhow"

But you don't need to remove the outer race (green cup) & that is where it begins to get very painful.

[Ascinder]

Originally Posted by nfpgasmask
Negative...I am not even sure I know what a micrometer is??

OK. I am sure Beau has one.

Yes he does, but what you really want is a dial indicator(which we also have). I looked up the CVs HERE
and didn't find any that crossed over. Your best bet would be to get exact stock measurements, then go to either pick and pull or like you said an autoparts or driveline shop and measure(and price) theirs. Many Isuzus use 17 spline shafts for outers. I assume inners are the same.

[CrnCnn]

Yes he does, but what you really want is a dial indicator(which we also have). I looked up the CVs HERE
and didn't find any that crossed over. Your best bet would be to get exact stock measurements, then go to either pick and pull or like you said an autoparts or driveline shop and measure(and price) theirs. Many Isuzus use 17 spline shafts for outers. I assume inners are the same.

I read up on some of Green dragons(Grampa Bob) posts and it looks like the right side was interchangable. I forget with what already, I need to start a list.

[Ascinder]

Then that means the website I cross referenced was either wrong, or the part numbers don't imply that the parts won't interchange, or the CVs are different, but not enough to matter.

[tom4bren]

idgaf27 wrote in another thread:

Isuzu Rodeo 93-97 AT
Isuzu Trooper 92-97 AT
Isuzu Trooper 98-02 w/TDS
Passport 94-97
SLX 96-99

half shafts fit ours.