Ordered the Infinity speakers

[VCrossfan]

Chop: Might be a dumb question but are the Infinity's replacing your 4 main stock one's in your VX??

I getting ready to upgrade my Pioneer head unit and the China(ebay) motorized monitor for an all-in-one Pioneer model AVH-P4900DVD touch screen also a Pioneer CD-IB100II iPod ADAPTER and a so-so Kenwood powered sub and I still have the stock speakers and will need to upgrade...I'm not after a crazy loud system just a nice comfy sound..

[Chopper]

Chop: Might be a dumb question but are the Infinity's replacing your 4 main stock one's in your VX??

I getting ready to upgrade my Pioneer head unit and the China(ebay) motorized monitor for an all-in-one Pioneer model AVH-P4900DVD touch screen also a Pioneer CD-IB100II iPod ADAPTER and a so-so Kenwood powered sub and I still have the stock speakers and will need to upgrade...I'm not after a crazy loud system just a nice comfy sound..

Yes, these are direct replacements. A bit of fitting is required for the rear, but not much really. No plastic will be cut. They will handle much more power than stock, but they require little power to operate well. Pretty efficient.

[VCrossfan]

Yes, these are direct replacements. A bit of fitting is required for the rear, but not much really. No plastic will be cut. They will handle much more power than stock, but they require little power to operate well. Pretty efficient.

Thank You sir...

[Toad80t]

Are you not replacing the tweeters??

[logman]

Could you by chance take a picture of your bracket after you make the larger hole for the new speakers? After seeing your order, I picked up a pair for the rear... ALL my speakers are blown. I think I need a hole saw, and the new hole diameter needs to be 5" correct??

I already got one side panel off WITHOUT breaking any clips/clip holders!! Those things are a pain...

Thanks.

[etlsport]

i used an angle grinder on mine




here are a couple photos of mine.. what i did was take the cardboard out of the box and use that as a template to see exactly where i should make my cuts, tried to avoid the nuts on the bracket but had to cut through one still

[Ldub]

i used an angle grinder on mine

I'm with ETL on this, an angle grinder would be the way to go, since you have no place for a pilot bit to keep you centered.
A hole saw would spin ya right round & get all kinda scary.