Center cap problems with certain wheels?

[tomdietrying]

Ryan, lol you need to go into ploitics after you win the olympics. The one I really liked was the very first one you started the thread about. lol

http://www.tirerack.com/wheels/Wheel...4x032&code=yes

Whatever you decide, I'm sure it will be the right decision.

Peace.
Tom
012009

[LittleBeast]

Ryan, lol you need to go into ploitics after you win the olympics. The one I really liked was the very first one you started the thread about. lol

http://www.tirerack.com/wheels/Wheel...4x032&code=yes

Whatever you decide, I'm sure it will be the right decision.

Peace.
Tom
012009

Ah I see sorry about that, yeah that would be great but it seems like there is two much center bore center cap problems to deal with but I found a couple new ones I like:

http://www.cwdwheels.com/images/whee...rome_large.jpg

http://www.cwdwheels.com/images/whee...lack_large.jpg

http://www.cwdwheels.com/images/whee...7_mb_large.jpg

http://www.cwdwheels.com/images/whee...lack_large.jpg


Now on to research about the offset.....

And politics huh? Well, it seems I am far too conservative for this day in age to run for office. But you never know

[rowhard]

Don't forget to look at MKW wheels, they have a few that will fit our beloved VX and if you look at their gallery, there is a nice looking dragon there, but then I would say that since it's mine.

[Kenny]

I can see the concern for center cap with those styles with hub inserts.
If it's any help, here's a few pics i have of the hub you have to avoid....

It sticks out almost 3" so the rim has to be either deep or have a center cap that is a protruding cup.

Good Luck.

[LittleBeast]

I can see the concern for center cap with those styles with hub inserts.
If it's any help, here's a few pics i have of the hub you have to avoid....

It sticks out almost 3" so the rim has to be either deep or have a center cap that is a protruding cup.

Good Luck.

Thanks a lot. I am still going through many different options. This hub problem is only an issue on the front wheels correct? Thanks again, those photos help a lot, especially since my VX is still at Aamco and I can't just run outside and visualise!

[tom4bren]

There's some pix in my gallery that show the front hub since I don't have center caps. Maybe that'll help answer some of your questions. There's no hub protrusion on the rear wheels (sorry, no close up pix).

[LittleBeast]

Just a little update on the center bore.
We do not need 108mm as I have seen listed around here.
The factory spare only has 98-100mm center bore, 8-10mm can make a huge difference when having wheels custom bored..... I would say if anyone was going to have wheels custom bored in the future 100mm is as wide as you need. Just a little FYI.