8 hours in the garage yesterday...

[etlsport]

Ahh I see. Yeah, you don't want to be knocking your cherry off and have it go into your back seat and burn something! I was just curious if you got one with a bad molding also...

Bart

yep it was mine that was off... not by much, heres a shot of the passenger side (the one that is off) and the drivers side (which was a good fit) I had to shave about 1/8-1/4" off of the end of the passenger side to get it to fit like it does now, when i got them (ordered from e-bay) the passenger side just wouldnt go because that tab was not lined up and would get in the way




my tip for anyone doing the scangauge thing... use a dremel to get close.. but do that last 1/8 inch by hand with some sand paper on a wood block then just test fit, shave a bit off, test fit etc until it fits snugly

[nfpgasmask]

my tip for anyone doing the scangauge thing... use a dremel to get close.. but do that last 1/8 inch by hand with some sand paper on a wood block then just test fit, shave a bit off, test fit etc until it fits snugly

So wait, your scanguage is embedded also? It didn't look like it in your photo. So you cut into the plastic there?

Bart

EDIT: OK, I just took a closer look at yours. Its so clean looking I couldn't even tell it was embedded! Nice!