To mount the winch plate I needed a length of 2x2x1/4” tubing. I really only needed a bit less than 5 feet worth. However, all the steel suppliers only sold it in 20 foot lengths. Now I have four, 5 foot length of steel tube. I am sure I can find a use for the rest, but still.

If I save the other 3 pieces for other projects (I already have some ideas) then the single piece was just over $25. Not to bad of a deal to make a winch mount. Not counting replacing my drill, I am so far around $75 into this mount. Or $150 if you count the total price of the steel plus winch plate. Either way not a bad deal. Now to go see if I can finish the frame mounts before the sun goes down.

Why does shopping taking so much time? LOL!