front end problems

[JAMAS]

How tight? Not, how do I tighten them...

I'm not THAT bad of a mechanic.....but close

I will definitely use loc-tite, thanks!

[tom4bren]

How tight? Not, how do I tighten them...

I'm not THAT bad of a mechanic.....but close

I will definitely use loc-tite, thanks!

Sorry, musta still had that mental image of you in a dunce cap sitting in the corner.

Look here:

http://www.vehicross.info/forums/sho...mmended+torque

[JAMAS]

Thanks for the direction.


I also decided to make it easy and just call our beloved Merlin to get the bolts.

$6 for 4 bolts and 4 nuts (in case the mount to the cross member needs one). I always buy twice as many as I need when the parts are cheap.

[JAMAS]

I received the nuts and bolts that I ordered from Merlin. I went to install them last night and quickly realized that I need to drop the cross member in order to even screw that bolt into the transfer case. I also couldn't tell if the mount was bad (like in Ldub's case HERE). So I think I am going to have to bite the bullet and have my local isuzu shop do it for me ($127.50 plus parts). Since they are dropping the cross member, I am going to purchase a new mount (from Merlin) and have them install that too. Is there anything else I should have them do since they are already going to have the cross member unbolted. I can't think of anything, but figured I would ask. I will most likely have them replace the crossmember bolts (crossmember to frame) for good measure.

[etlsport]

could have them drop the transmission pan and replace the filter

[Ldub]

I received the nuts and bolts that I ordered from Merlin. I went to install them last night and quickly realized that I need to drop the cross member in order to even screw that bolt into the transfer case. I also couldn't tell if the mount was bad (like in Ldub's case HERE). So I think I am going to have to bite the bullet and have my local isuzu shop do it for me ($127.50 plus parts). Since they are dropping the cross member, I am going to purchase a new mount (from Merlin) and have them install that too. Is there anything else I should have them do since they are already going to have the cross member unbolted. I can't think of anything, but figured I would ask. I will most likely have them replace the crossmember bolts (crossmember to frame) for good measure.

could have them drop the transmission pan and replace the filter

I agree with Eric, do the tranny filter...

Also, Ive had my cross member off 3-4 times, & never replaced the bolts...

Just clean em up good & give em' a new application of loc-tite.

[JAMAS]

I called to see what my added cost would be to have the transmission filter replaced......$350(total parts and labor with new transmission mount).

They basically broke it down like a transmission service, then subtracted the cost to replace the mount. So I get a tranny service with a free trans mount installation. The $150 its gonna cost me to purchase and install the new mount was pricey enough for now. Since the cost is so low on the bolts, I went ahead and ordered new bolts all around. Cross member to frame, heat shield to cross member, mount to cross member, and mount to tranny.


Also.....should I use Red or Blue Loc-Tite for the bolts?
--------
This is from an Isuzu dealer, service shop that I have dealt with (and loved) since I got my VX. So its really the only place I want to have anything done.
--------