Page 2 of 2 FirstFirst 1 2
Results 16 to 21 of 21

Thread: Engine starts, then dies

  1. #16
    Member Since
    Feb 2007
    Location
    2000 Proton VX - 0776
    Posts
    9,258
    Thanked: 0
    Might sound kind of odd but check to make sure your gas cap is on tight. Also check to make sure your oil fill cap is on tight & that the gasket is not hard. Not sure why either is critical but I've seen that cause similar problems on other cars.
    [SIGPIC][/SIGPIC]

    Put a smiley after you say that Bub.

  2. #17
    Member Since
    Feb 2006
    Location
    2001,Kaiser Silver, VX, 0563
    Posts
    4,767
    Thanked: 0
    judging from reading the other posts.. i wouldnt guess it would be a starter issue.. sounds like a fuel delivery issue.. id start at the fuel filter as thats cheapest, if that doesnt fix it try fuel pressure regulator


    "Engineers believe if it ain't broke, it doesn't have enough features yet"

  3. #18
    Member Since
    Jul 2005
    Location
    ex 1999 ebony black vx 1979
    Posts
    125
    Thanked: 0
    When mine did that it was the idle control valve. Inexpensive part, easy quick fix.

  4. #19
    Member Since
    Jun 2005
    Location
    01 Dragon Green VX 1286
    Posts
    423
    Thanked: 0
    Mine did it.. and it ended up being a low water level problem..no codes.. goodluck

  5. #20
    Member Since
    Feb 2006
    Location
    2001, Proton, 0869
    Posts
    2
    Thanked: 0
    Mine has been doing this lately, I need to take it in but it looks like I can reproduce it by driving around w/ the AC on and turning off the car while it is on. Upon restart it exhibits the idling issue.

  6. #21
    Member Since
    Feb 2007
    Location
    1999,silver,vehicross,1891
    Posts
    186
    Thanked: 0
    mine fails in driveway, has happened during high humidity, when it rains more often. I have been swapping TP Sensors (TPS sensor) for about 2 years. I disconnect the ground each time when I change out the sensor. After reconnecting, the CPU re-learns the TPS. Does die on first try while learning. On 2nd startup attemp always works. If I do not disconnect the ground and just swap sensor that car really rumbles and grumbles, has not idea what the engine is doing, back fires, mis-fires, shakes, rattles and rolls. That happened once when I forgot to disconnect ground wire. Started procedure over that time, and all was fine. Now about 3 weeks later it did same thing, starts and dies in driveway. Never done it while driving. This time, I swapped back in the previous sensor. All is well again. What else I am resetting that has to do with simple startup idle when I disconnect ground? Never any codes to read. Idle Control Vale cause this?

Similar Threads

  1. Replies: 17
    Last Post: 09/21/2017, 10:15 AM
  2. Engine starts up and dies
    By Baldwin in forum VX Troubleshooting...
    Replies: 20
    Last Post: 07/09/2016, 05:14 AM
  3. Replies: 4
    Last Post: 11/09/2013, 07:21 AM
  4. Engine suddenly dies...
    By Buffy in forum VX Troubleshooting...
    Replies: 16
    Last Post: 04/22/2011, 06:51 PM
  5. Engine starts then shuts off
    By deldorado in forum VX Troubleshooting...
    Replies: 7
    Last Post: 05/07/2003, 01:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails