Diff Drop Brackets

[CrnCnn]

Bought a spare from that glenn guy that made a post here with a wrecked VX. If I remember correctly it was the one eric=etl went and visited.

Im still in the runnings for getting kpsake's too, considering I was first to request them.

Nice, he never responded to me about them. (Glenn). If you get yours done can I be in the running to get a set from you?

[ZEUS]

OK, I finally posted these pics. I only lowered one side of the crossmember (CM) - the diff side. The other side does not need to be lowered. I used 2x3 square tubing and cut one side off. I ground down the end of the CM to attach the tubing to to it. I put one bolt in the CM on the driver side and put the tube in place and used a jack to bring the CM up against it (in its new mounted location). I tack welded the tube to the CM and removed the assembly for welding. When that was done I mounted the CM again and eyeballed where the new mounting hole would be then drilled it in place. As you can see, my pinion seal needs to be replaced... again!

[tom4bren]

Thanks ZEUS,

That's sorta what I had in mind but was hoping to come up with something 'bolt on' that I could send out with the drop brackets. I'll let you know if I come up with anything simple/cheap/strong (pick any 2).