BBVX's way looks good too without the pulley or the solid wire hook that comes in the kit (it should have had instructions for it on a separate piece of paper). I only saw the part about the pulley but if you look at some of the pictures, I thought the rigid wire thing was shown. The hook hooks under the latch mechanism, the cable it attached to the rigid wire thingy with the attached screw and clamp. The cable runs up from the solenoid, over the pulley, and then hooks under the latch mechanism. The you adjust either the pulley or the cable length until the cable is almost taught. If the VX is off, it typically takes two pushes of the release button to open the door fully. When running, it only takes one due to additional current flowing through the system. I spent an hour adjusting and adjusting until I figured that one out.