Tone,

I did print out your instructions, and I'll check on the CD again, but the pictures that I saw never said how to connect the rigid wire end to the door release mechanism. From the looks of the pictures where you have the solenoid and the pulley mounted means that the wire from the solenoid has to move a little perpendicular to the pulley to get back to the release mechanism. Is that the case? If so, is there any issue with the wire jumping off of the pulley as it goes up and back out of the solenoid to the pulley, and then down and back from the pulley to the release mechanism?

Thanks for the help. So far the instructions, and the kit, have been very helpful and easy to install.

See you on the 15th for the Zuvoy!!

Mark