replace stereo??

[rowhard]

When I replaced mine a few weeks ago, I removed the mount that surrounded the old unit, held in place with 4 screws and slipped it over the new unit. They seem to come with standard mounting hole to make it easy for everyone. Then it just slipped in just like it was made for it. I in fact mounted mine where the cd changer went and installed the scan gauge in the upper hole. Circuit City could not supply a connector so I had to cut and splice, but that was really not a problem. Just used the wiring schematic to match up the wires. Think I only used I think 10 of the 13 wires which at first made me wonder but it worked out just fine.

[Knigh7s]

Here they are:
Install Instructions

[etlsport]

i did the same thing rowhard was talking about, using the four screws that hold the stock units in place to attach my new unit, my screen i had to do some modding of it since i mounted it upside down... and again like rowhard i had to extend wires, so i ended up only extending the power, illumination, and switched power to the new unit, i made my own ground, and use RCA out of the head unit to an amp to power all the speakers

[disasterlady]

THANKS KNIGHS7S! This should do it... I will attempt the job at the end of the week and let you all know how it turned out.

Once again thanks everyone for your input... got me thinkin!

disasterlady

[Knigh7s]

Just dont forget the wireharness, so u dont have to be spicing the factory one.

[MZ-N10]

Just dont forget the wireharness, so u dont have to be spicing the factory one.

splicing the harness wasnt tat bad....sure was dumb of me tho...