new tires

[psychos2]

A LITTLE trimming - not!

Stock tire is 29.5" tall and 9.64" wide
285/75/16 is almost 33" tall and 11.2" wide.

They are actually 33.1" tall and 11.3" wide. I went 2" bigger than stock and it was a little trimming.That size would need a lot of trimming.As others have already said. shawn

[Kahuna]

Guys...I have put on that size tire and I tell you, it was only a little trimming. I did put on OME912, and crank the tbars. Had to do only a little mod to both the front and back of the wheel well. It's snug, but on a full radius turn, it clears without a problem.

[Triathlete]

Guys...I have put on that size tire and I tell you, it was only a little trimming. I did put on OME912, and crank the tbars. Had to do only a little mod to both the front and back of the wheel well. It's snug, but on a full radius turn, it clears without a problem.

For street use may be okay but it you take it off road at all and flex the suspension a little you'll be rubbing. With a lift and only 31's I still get some rubbing.

[Tone]

Psycho, are those the tire companies specs as I used a calculator for the average size.

Gee, Kahuna sounds like you had to do ALL of the items I mentioned...

[psychos2]

Psycho, are those the tire companies specs as I used a calculator for the average size.

Yes they are. shawn

[JULIAN911]

Those won't fit! I've got a 2" lift and had to trim a bunch - still rub slightly when turning and going over bumps.

[driver3]

I have 265/75/16's.. they are exactly perfect.. I had to trim off maybe a 1/4 inch when I ran chains in the snow.. also.. I've run the front cladding into the ground a number of times.. sometimes I start rubbing again... that front cladding can bend in a little so some people's may be different than others. I hardly believe that without a lift, looking at the tires I have, you will ever fit those on there...