Dumb question...

[Cyrk]

Bart what rims are you thinking about getting?

[nfpgasmask]

Bart what rims are you thinking about getting?

C'mon! Do I have to tell!

Bart

[VehiX]

Good luck getting the Isuzu logos off the caps!

I don't know what they used for an adhesive but they're on there pretty darn good

All 4 caps on my 16's took about 4 hours to remove on a hot day using some type of adhesive remover (the brand I used escapes me at the moment)

[nfpgasmask]

Well, what about just leaving the caps on, sanding them down good, masking off, and respraying right over top??

That was my plan anyway....

Bart

Good luck getting the Isuzu logos off the caps!

I don't know what they used for an adhesive but they're on there pretty darn good

All 4 caps on my 16's took about 4 hours to remove on a hot day using some type of adhesive remover (the brand I used escapes me at the moment)

[Ldub]

OORRRRR...
You could go to most any sigh/graphics shop & buy a piece of black decal paper & cut 4 circles to go over the center.

Don't know which would work best...pre-cut or cut in place w/ a zacto knife.

Think that's bad ?...

My first idea was just a piece of lec'tishin's tape.

[nfpgasmask]

Hmmm, I do have some black contact paper around here somewhere. That acutually isn't a bad idea, but something like that could only be temporary (probably wouldn't hold up to snow and salt and heat for very long). I think some good paint with a good enamel top coat will do the trick.

Bart

OORRRRR...
You could go to most any sigh/graphics shop & buy a piece of black decal paper & cut 4 circles to go over the center.

Don't know which would work best...pre-cut or cut in place w/ a zacto knife.

Think that's bad ?...

My first idea was just a piece of lec'tishin's tape.