Replacing Wheel Bearings?

[driver3]

and buy some extra screws for the hub nut ring as you will almost certainly strip them

I use an impact driver to pop them loose.. I've never had to replace one.. I can see how with a normal screwdriver they would get stripped though, I just did mine recently.. when you do the rotors you can repack the bearings... inspect them and they may not need to be replaced... I will say I have both the screws and the bearings in my toolbox in the event I need them

[mrlegoman]

I'm still looking for my Mitchells CD....it's around here somewhere.
The VC belongs to my girlfriend. So 120K and no maintenance on the wheel-bearings what-so-ever. I can't even get her to check the oil.

That Planet Isuzu article looks awesome, thanks to all!

[mrlegoman]

No luck finding my Mitchell's CD.
Alright, planetisuzoo's guide seemed straight forward.
I'm off to Autozone, here's the checklist:

Inner & outer bearings
Grease Seal (or is this part of the inner bearing?)
Hub nut tool (modified Ford)
Seal Puller (what is this exactly?)
Spring scale

I'm a little unclear on the use of the spring scale, but I guess I can figure it out.

How are the rear hubs setup?