whats a prerunner fender?
whats a prerunner fender?
"You can live your life in a thousand ways,
but it all comes down to that single day,
when you realize what you regret,
but you cant relaim and you cant forget."
----Trans Siberian Orchestra
I know sawzall makes one but I need my fenders to sit wider to fit lambo hinges (don't judge me).
A prerunner fender is commonly made out of fiberglass and sits wider and deeper to usually make more room for articulation and a place for your tires to go when you jump. You see them on baja and desert race trucks.
Most fiberglass shops should be able to lay up some for you.
Billy Oliver
15xIronman
My Sponsors:
Accelerate3Coaching
TriSports.com (PM me for 1 time use 20% off code)
Ya, good luck finding just about ANY aftermarket product for the VX. And if you do.... SHARE!
Especially considering most ISUZU dealers don't even know what a VehiCROSS is. True story when I went to buy my WRX a couple months ago. It was also a Zu dealer and I asked 2 salesmen if they had seen any used VehiCROSSs on the lot lately (must say VehiCROSS, not VX to mortals.... they will look at you as the RCA dog would). Long story short, nothing came of that discussion, even after explaining the VX to them. To them, the VX is a myth.... wish I had driven mine, but then.... how does one drive 2 vehicles home.... hmmmmmmmmm.
But ya, anyways, it's always good to share good aftermarket findings with everyone. Pre-runners would look pretty kicka55 on a VX.
*sorry for the A.D.D. moment there*
Gary Noonan
'01 S/C VX / '18 Forester XT
The Vcross in the middle of the page is a nice street setup..(with extra pic's)..I'm sure there not mass produce but gives you an idea what can be done..Click Here
[SIGPIC][/SIGPIC]
" Jeeps are nice, Barbie has one"
I wonder if that was fabricated from scratch or built up off of existing cladding...
Nice work, even if I consider it a bit OVERdone...
~ ~ ~
Van Eyes - slightly trimmed, Sylvania SilverStar ULTRA head lamps, Red (port) & green (starboard) 5 LED 'headlight horn' lights, PIAA silicone windshield wipers, K&N Filtercharger (in stock air box), MacNeil WeatherFlectors, Assorted cargo nets from previous vehicles, Optima red-top battery, Transmission Interceptor, 20 LED 'light tower' turn signals & brake lights, 18W PIAA W2 running lights, Trooper skid plates, Black Luverne step bars w/Tone's custom brackets
That's that one-off MoonCraft VX that has the funky turbo set-up.
IIRC, they made all new cladding for that out of ABS.
Modding our fenders for scissor-doors could be tricky if you've ever seen them without the cladding on. It's just flat sheet metal under there, so you'd likely need to fab something completely different using the stock fender cladding as a start.
Over 20 years of Isuzu enjoyment...