Fill with remainder of grease.
Now slide the large end of the boot into place and secure it with the supplied strap. Burp the air and slide the small end into place on the shaft. Apply the small strap.

Now reposition the ball joint bracket back under the lower control arm.
Use the jack to lift the control arm until the holes line up for the bolts.
Insert the bolts and tighten up the nuts. Torque specs are found in your manual.
Put your wheel back on.
Repeat for other side if needed.
Lift VX with jack.
Remove jack stands.
Lower VX.
You ready to roll with a lot of saved cash in your pocket for your trip to Moab next May!