Originally Posted by taylorRichie
Hey Larry,
Can you tell me your approximate time to completion for one side, while being lackadaisical?
I'll add 25% and figure that's about where I'd land
Finally got around to doing the drivers side today...this foray into the world of mechanical things only took me three hours, start to finish.
As mentioned before, I always take my time, have lots of coffee & smoke breaks, & generally look at how things work as I take them apart.
There is no "Indy pit crew" in my genetic make up...
One thing I did discover, that makes manipulating the assembeled inner knuckle/cage/ball bearings into place easier...remove the lower bump stop (two bolts) & you can swing the CV shaft towards the rear to get a better, more accessible shot at the snap ring. Makes re-assembly much easier.
Reply With Quote