Window woes...

[creeg]

From the picture it appears to me that the window should sit at almost exactly the same height using either tab. Is it possible that there is some play somewhere else, perhaps where the tabs attach to the rails?

That could very well be the case. They should sit at the same height.

I could also have neglected to push the tab on all the way when gluing the new one, and there could be a bit of glue on the bottom side of the glass that is casuing a spacing issue.

One thing is that if you look at the side-by-side comparison, the holes line up: but the bottom of the "seat" for the glass (ie, the plastic "U" shape that holds the glass, not the part that screws into the control arm) seems to be at a different height. But a) I dont know if that matters and b) I would think it would cause the window to sit a little lower, not higher, with the new tab.



Not really sure...

[etlsport]

neither one of my windows goes all the way down.. they both stop with about 1/8-1/4 inch sticking out of the door?? i figured it was normal

[Kenny]

neither one of my windows goes all the way down.. they both stop with about 1/8-1/4 inch sticking out of the door?? i figured it was normal

That's not normal, especially if it's uncomfortable to put your arm there to rest when the windows open.

You might be able to adjust the wire pulley system at the winch to correct this. But I'm just guessing here... It's not easy to get to.

Also, if you were to lower it, would it still close at the top fully? hmmm.

Good luck,