BORBETS finally on! question, though..

[2K1 1K2]

well, after a lengthy time in the garage, the BORBETS purchased from Ron, are, finally, on the VX.

However...

Ron or Cyrk, are you there?

I have shaved a bit of the front cladding at the front of the wheel wheel to accomodate some space for turning but the tires are rubbing on the the rear lower corner of the cladding along with the 1st screw (bottom one, which holds the cladding to the body?). I could probably shave the cladding a bit, but, what am I to do with the screw? I'm afraid to make a sharp rolling turn and tear off the bumper!

any advise would be appreciated. GRACIAS!

- jose

[Cyrk]

Congrats, not sure as I have mine mounted with 255/55/18 Toyo's and no trimming was needed. Sorry and post some pics when you can!

[2K1 1K2]

cyrk,

thanks for the prompt response. i'll be sure to post pics, once all is set.
take care!

-jose

[Ldub]

[Chopper]

Lift it up a bit!

[2K1 1K2]

thanks, for the replies.

i'll be performing minor surgery tomorrow. wish me luck.
pics to follow (if i can get that right!)

-jose