Results 1 to 15 of 22

Thread: help vx dies while driving

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Member Since
    Mar 2006
    Location
    2001, Orange (ex-Proton), #0758
    Posts
    369
    Thanked: 0
    Quote Originally Posted by Ruflyf
    just died while i was driveing about 10mph engine turns over sound fine but is not trying to start..lack of fuel or spark ? timing belt maybe ??

    any ideas on what to check and where ?
    Try to do the following (in either case it would be good for your VX):
    - buy carb cleaner spray
    - remove intake air hose from throttle valve side
    - spray a lot with carb cleaner untill throttle valve will cleanup from carbon and will look like a "brand new", you might want to move valve with throttle lever to clean it better, especially close to the axis.
    - unscrew idle control valve, remove rubber gasket (it is reusable, so keep it) from it and spray a lot on the valve (do not spray close to the painted parts, it might be damaged by the spray) then clean up it with cloth.
    - spray a lot into the hole where idle control valve is installed
    - assemble everything back and start engine (do not worry if RPMs at idle will raise up to 3000 for the short period: it is because of carb cleaner burning in the engine)

    Hope it will help.

  2. #2
    Member Since
    Mar 2005
    Location
    buying one
    Posts
    19
    Thanked: 0

    neither the starter or the flywheel

    I had a second machanic look at it and he pulled out the starter and said it's fine, said it's the crankshaft, which is under warranty I beleive cause this is the 2nd engine in it and thats got a 5 year, 100,000 mile warranty on it.

  3. #3
    disasterlady Guest

    Arrow mine did that

    mine did that and it turned out to be just that I didn't tighten the gas cap and the so the vacuum wasn't there for the fuel... you could try it?

  4. #4
    Member Since
    Jan 2006
    Location
    2001, Kaiser Silver, Vehicross, 0219
    Posts
    818
    Thanked: 0
    Ditto what disasterlady said. That happened to the 1.8t jetta after boosting it to hard. about 1/4 mile the car died, checked the cas cap in it was only half screwed in. all i did was tighten it and cranked it a couple times and it started right up. i recal having to do that once with the vx to, minus the boosting O_o
    01 VX Kaiser | Love it! Drive it! Mod it! MYVEHICROSS.com | VX-WIKI

    Rancho RS9000X | VXC Shifter Plates | PV2 | Hella Micro DE fogs | Carbon Fiber Hood | AfterShock Skid Plates (front, rear, sides)

  5. #5
    Member Since
    May 2004
    Location
    99 Astral Silver w/ SC
    Posts
    485
    Thanked: 0
    The final consensus for me was a short in the wiring harness behind the drivers side headlight area. I started looking for the short, but couldnt find anything, apparently moving it around made it to where it no longer is touching anything because it hasnt done it since.
    "You can live your life in a thousand ways,
    but it all comes down to that single day,
    when you realize what you regret,
    but you cant relaim and you cant forget."
    ----Trans Siberian Orchestra

Similar Threads

  1. Replies: 17
    Last Post: 09/21/2017, 10:15 AM
  2. Engine starts, then dies
    By crager34 in forum VX Troubleshooting...
    Replies: 20
    Last Post: 09/12/2017, 09:52 PM
  3. Engine suddenly dies...
    By Buffy in forum VX Troubleshooting...
    Replies: 16
    Last Post: 04/22/2011, 06:51 PM
  4. VX Stalls and Dies While Driving
    By Clyde in forum VX Troubleshooting...
    Replies: 36
    Last Post: 08/07/2007, 07:33 PM
  5. John DeLorean Dies at 80
    By Heraclid in forum VX Talk...
    Replies: 5
    Last Post: 03/21/2005, 03:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails