Suspension "clunk"

[luz]

I had clunks under hard braking that went away when I lubed the joints.

[Triathlete]

Hmmmm, hasn't happened again. I hate phantom problems...never know what it was or when it might rear its head again!

[etlsport]

luz, where did you lube/what did you use? i get a clunk during take off after a hard brake

[luz]

I used Mobil One Synthetic grease. There are other posts in the forum that discuss lubing the joints, but it's really easy.

There are three spots where there is a nipple or zerk joint that you plug your grease gun into. One on each U Joint and one on the shaft. Park on a level surface and if you can't get to the nipples, move the VX up or down a foot to where the shaft rotates and you can access the nipples.

Just be sure to get a grease gun with flexible tubing because it's hard to get a good angle without it. You can plug into the zerks and squeeze new grease into the joints until the old grease oozes out. Wipe off the excess and you're good to go. But be advised that the one on the shaft takes a while to fill up if it's completely dry as mine was.

[Triathlete]

Now it started doing in while going forward also (to a lesser extent). I think I've narrowed it down to the rear end. Sounds like the LSD is engaging (the jerking feels like the right side). Is the left side the usual drive side until the LSD locks up? When I changed out the diff fluid with mobil1 I only put one bottle of additive in it. Tomorrow I'm going to get a second and add to it plus check the fluid level (although there are no signs of leakage). We'll see what happens. Got two weeks to figure it out before heading to Moab.

[Triathlete]

Okay...so today I checked the gear oil level in the diff. It was good. I then added a second tube of LSD additive. I lubed the 3 zerk fittings on the driveshaft with Mobil1 synth grease. I removed the rear right tire and inspected the brakes and rotor. Everything is or appears good.
Went for a test drive. I am getting a clunking sound (almost like something binding) while driving straight. The sound sounds like it is coming from the right rear although it could just be transmiting to that area. The noise dos not happen all the time It will happen 2 or 3 times real quick then not happen again for a while. I am stumped. Anyone have any more Ideas? I've got 2 weeks to figure this out before I head to Moab.

[Triathlete]

Next up will be changing the U joint. Reading the manual and it soinds like this might be the problem (fingers crossed).