hood release

[Cobrajet]

When mine had this problem I used a piece of pipe insulation wedged in the latch to hold it up while I ran to the front to lift the hood. I did this for several months until my next major service and then got the dealer to adjust it correctly. I tried to adjust the hood latch and rubber bumpers myself, but could never get it to work properly. My hood still doesn't "pop up" when I pull the lever and sticks just a little before opening. There is no spring in mine to initiate the lift. Is this a design flaw?

[etlsport]

this is probably somethin youve already tried.. but when i took my dash off, i pulled the hood release lever out too.. when i put it all back together, hood wouldnt release, so took it apart again and realized the hood release actually can be mounted in different positions, so i pulled the whole assembly as far forward (towards the seat) as i could before tightening the screws, havent had any trouble since

[Knigh7s]

Had this same problem when I first bought mine back in Jan. When you ever do get it open, just spray some liquid wrench or WD40 on the latch and let it soak. then close the hood and pull the lever several times to break the old grease and grime that accumulates over time. Worked for me.

[VehiGAZ]

Lube worked for me too. You probably don't need an adjustment - especially not when it'll cost you a half hour at the dealer service rate! Road dirt gets in that mechanism and prevents it from moving freely, which is why it doesn't pop up when you pull the lever (in most cases). You just have to WD40 it every now and then. I've had to do this at one point or another on almost every car I ever owned.

Never forget the Golden Rule of Automotive Repair...

All you need to fix anything on a car is WD40 and duct tape - if it's supposed to move and doesn't, use the WD40. If it's not supposed to move and it does, use the tape. :-)