Musings about Mothering the Cladding

[creeg]

One other thing I was thinking about with Rhino Lining and Line-X: they have no-skid surfaces, which to me means, basically, that they have a rough surface, making for potentially more wind resistance than the bare cladding (and potentially using more fuel)

Since the cladding already has a slightly rough surface, I dont know how much MORE wind resistance (and fuel usage) it would add. Anyone have any experience with that, or can make an educated guess?

[Joe_Black]

Caring for the cladding is only as hard as you want it to be. I've never had an issue with Meguiars Endurance streaking in rain, then again I wipe all the cladding down with a clean old t-shirt about an hour after applying.

Here's a simple and easy way to get nasty cladding back to good:

Find a good shady area, preferably a car port, to wash the cladding. Use soft, clean cotton towels to wash the cladding with A mild mixture of Dawn liquid dishwashing detergent. This will get any grease, oil or was off the cladding. Once that's done, rinse very well. You can even drive down to the local self-service car wash and use the pressure washer about 3 - 4 inches from the cladding surface. You'll see what I mean if you do this. Then dry with some more cotton towels and if you have a super leaf blower use that to help get the water out of the crevices. Then go do something else for a while to allow the VX to thoroughly dry.

Come back and use a rectangular cotton applicator pad to start applying the Endurance Gold. Keep the pad liberally damp with the product and use smooth even wipes to apply. The edge of the applicator is good for getting into the nooks and crannies. Go do something else for about an hour when done, then come back with a clean old t-shirt and wipe all the excess off the cladding. This really makes the difference when using the Meguiars product.

That's it, your done for a few months or until you can't stand it anymore.

[Navigator]

Don't leave behind any residue, buff the cladding dry after use. I must admit, in the begining I used to use it like tire shine and leave a shiny layer behind that would collect dust and streak when wet. It wasn't until I read the bottle that I learned that this stuf is meant to remove the crud from your cladding that makes it look faded. You need to let this stuff work its way in for a few hours then buff it dry with clean terry towels. I go thru several towels as to avoid redistributing crud. The results will not collect dust or streak when wet and last for months.

For those with streaks you are 90% done, just buff it with some clean towels.

Also avoid machine car washes. The additives tend to whiten the cladding. Use only plain water to clean your VX or any car for that matter