1)easier to put VX on stands where whole front end is lifted to relieve pressure
2) Get a hammer and a punch to mark location of beginning turn.
3) each full turn is like 1/8" to 1/4" I can not remember
3) once you figure how much lift you need lower and bounce it around from side to side and up and down to allow Tbars to adjust
4) Reapeat step 3 if needed
once you lift it
1) Remove wheel undo lower(smaller around) clamp from inner Cv boots and push them up over the groove where they were suposed to set in to alleviate stretching and tearing from lifting.
2) replace clamp with very strong Flex cuff