Results 1 to 4 of 4

Thread: crank pulley size question

  1. #1

    crank pulley size question

    well, thats pretty much it. Any one know the diameter? I figure tone or someone else that has put in S/C might be able to take a guess?

  2. #2
    Member Since
    Jun 2002
    '99 SC Ebony #1961
    Thanked: 0
    55mm is the standard pulley size, measured with the belt off, inner ridge to ridge.

    From Tone...

  3. #3
    thanks cyrk, but i think thats the s/c pully size. I was wondering what the size of the stock pully on the crank is. i just mentioned the s/c'ed guys b/c i figured they were digging around down there to install it.
    Last edited by spitfire5454 : 02/02/2006 at 03:48 PM

  4. #4
    Member Since
    Jun 2002
    '99 Ebony Black VX, 0339
    Thanked: 0


    Excuse me but if you have a VX, crawl underneath,measure it, and then post that information for other- it's right in the open.... OR I COULD GUESS, 7

Similar Threads

  1. Quick Question on Center Console Size
    By vt_maverick in forum VX Talk...
    Replies: 12
    Last Post: 07/09/2014, 07:50 PM
  2. Wheel Size Question
    By cyronman in forum VX Modifications...
    Replies: 10
    Last Post: 07/06/2007, 12:06 PM
  3. Timing Belt Replaced - Crank Pulley Question
    By SilverBullet75 in forum VX Troubleshooting...
    Replies: 8
    Last Post: 08/19/2006, 03:49 PM
  4. Question on LCD touchscrn size/mounting...
    By viruscauser in forum VX Modifications...
    Replies: 14
    Last Post: 04/16/2006, 10:48 AM
  5. Tire size question....
    By SRCHN in forum VX Talk...
    Replies: 10
    Last Post: 11/03/2005, 09:19 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts