Tail Light Guards

[wekilled]

Came back up for air (back to schoolwork tomorrow). I didn't mess with the curvature of the guards themselves (no pipe bender avail-or anything besides simple power tools and sidewalk, which is like cowbell, you can never have too much) All I did was use a Dremel to shorten the tubing you see in the pic--figured it would be a useful spot to mount stuff later --the pic you had with the CB antenna mount (BINGO, I LOVE the antenna mount). I then had the weld shop take three pieces of flat steel and weld it at a 45degree angle on the inside of the guard. Then vise grips, crescent wrench and some educated guesswork and just bent them to fit. One reason I have them so far from the tail light is the mismatch same as the plastic ones on the angles, it doesn't look as odd when they are further out (and they match the distance on my Mercedes grilleguard anyway)