Quote Originally Posted by VCrossfan
kpaske

When I installed mine I disassembled it down to the belt reinstalled the crank pulley bolt turned it over by hand (breaker bar) time after time and if I remember right every 3 revolutions of the Crank all the marks lined up with the crank notch at 3:00 lining up with the oil pump line that is on the block (at 3:00). Once I knew where I wanted to be I removed the tensioner and installed the new belt lining up the marks as mentioned without moving anything (cams,crank)

The picture in the scan shows the notch (behind the crank pulley) at 3:00 aiming at the line thats on the block. The only alignment mark for the crank is on the block at 3:00...
VCrossfan,
the mark on the block lines up at 3:00 with the notch . but the mark on the belt lines up at 9:00 with a dot on the opposite side.and again the #8 diagram is for the crank not the cam. shawn