Quote Originally Posted by kpaske
Joe -

Yes, I think that is how I did it. The only part that looks unfamiliar is item 8 - I didn't line anything up on the left side of the cam shaft pulley, I just located the notch on the pulley (I'm pretty sure there was only one), and it lined up exactly with the mark at number 7.
i was looking at the cd manual and noticed what you had said in an earlier post.the reference to 8 in the diagram is for the crank not the cam pulley.and i also noticed that in the manual it says to make sure the writing is facing so you can read it from the front of the vehicle.so my question is did you line the crankshaft mark on the belt to the drivers side or the passenger side of the motor? because you line up the mark on the drivers side with the mark on the crank pulley and then you line up the mark on the belt with the mark on the passenger side of the crankshaft gear.
do not know if this is what you did ,but i was confused when i first looked at the diagram.hope this helps shawn