So if it is, in fact, 180 degrees off, it should be relatively easy to put it back in phase, right? I'm guessing that one cycle of the #2 cylinder is what it would take? In other words, rotate the drivers side cam until the piston moves from TDC, to the bottom, and back to TDC?
I don't think I'm one tooth off though - I took extra care to ensure that everything looked exact, and lined up the double line on the belt with the mark on the crank shaft pulley, leaving little doubt. I drew a little line on the belt tooth that corresponds to that mark so it would be easy to see when it lined up, and the lines on the cams line up fairly easily. Also, the cams sort of "pop" into place, so I think it's hard to screw those up.
The belt is a Gatorback, which is what several other members have used, so unless it is defective, there shouldn't be any issues with fitment.
If you guys are pretty sure it is 180 degrees off, if you could just confirm what the best way to make absolutely sure everything is lined up correctly, I've got no problem tearing it down and putting it back together. Third time's a charm, right?
P.S. Mbeach - I didn't think the "RLTW" was a dig, I just wasn't sure if there was some other meaning to the acronym, as I didn't think most people knew it to mean what I know it to mean. I'm surprised you remembered I'm with 2nd Bat.
Reply With Quote