Magnaflow catback

[Cyrk]

I just got off the phone with the shop... the back pressure is reading 6psi which is too much back pressure for a SC motor... Should be reading 2 to 3psi.

So he is fabbing up a 2.5" dual cataback with magnaflow cats, new bungs for the O2 sensors and mufflers. I am excited to see how it turns out... He says I should feel a nice difference over the PV since when that exhaust was made, it was more for a NA engine.

Will go get it Dyno'd again to see. Will post later when I get her back. We are also powder coating my intake black to lower the heat coming from the shinny chrome intake pipe.

So does anyone want to buy my PV catback?

-Dave

[AnalogVX]

I like how the PV1 catback sounds...(read Nocturnal) and have been searching for something similar. You are a few days late! LOL!
anyway... Spazz, clear some PMs out...I can't reach you.

Here's some numbers and links:


Muffler #14325 at
http://www.a-1performance.com/magnaf...mfm_4x9_ss.cfm

IEM111SS Stainless tip at

http://www.grabthepower.com/spec-stainless-tips.html

I got a couple sound clips from the interior, but it does not do it justice to how well it sounds. It is louder than the sound clip...but still sounds good. I will try and post it. It's an mpeg from a digital camera, so it's gonna take me a bit to figure out how.

[MachineVX]

So, they're adding new magnaflow cats (what size? could you get us the part numbers)?

and going to dual mufflers? or is it one muffler with two pipes out for the dual exhaust?

Any part numbers would be appreciated!

[tomdietrying]

I just installed the FlowMaster and I love it. It gives my VX a nice, beefy, mellow, throaty sound.

I would recommend it.

Peace.
Tom